The TS350-MDX Hotline Telephone will automatically dial a pre-programmed
number whenever the user lifts the handset off hook. Great for Kiosk or Courtesy Desk.
The TS351-MDX Hotline Telephone will automatically dial a pre-programmed
number whenever the user lifts the handset off hook.
Automatically connect to customer service.
Install phones in public areas for emergencys.
Kiosk customer service phone.
Install in elevator to automatically connect to emergencey number.
The LX350-MDX Hotline auto dialer will automatically dial a pre-programmed whenever the associated telephone goes off hook. Small enough to fit inside telephone.
The LX350-C2 is telephone line powered and will operate on any PBX, Centrex, or standard loop start central office line or voip ata. The LX350-C2 Hotline auto dialer will automatically dial a pre-programmed whenever the associated telephone goes off hook.
The LX210 Dialer is a single line, line powered dialer that will dial out on POTS lines or analog station ports. No external power or batteries are required. Simply connect the LX210 Dialer Dialer to an analog phone line or station port, push the White button, and it dials the pre-programmed phone number. Mount the LX210 Dialer in plain sight, or mount it under a desk. It can dial the next desk, next door, the next city, or the next country...
The LPD100 allows two phones to share the same phone line. When the Priority Phone goes off-hook, the LPD100 hangs-up the line for a couple of seconds to get rid of any existing call, and then gives the Priority Phone a new dial tone. The Non-Priority Phone will be dead while the Priority Phone is in-use. The LPD100 has a Dry Closure (low voltage, low current relay contacts) to allow you to set off a light, bell, siren or alarm to notify someone that the Priority Phone is being used. No external power or batteries are required.
The TC100 will detect the howler tone (used on real phone lines), dial, busy or reorder tone, and hang up the phone line for about 800ms, creating an open loop CPC signal.
A great device for phones without a flash key or no buttons left to program as a flash key. Put it on an Automated Attendant and allow it to do a Centrex flash right on the CO line, to transfer calls off premise. Put it on a cordless phone with no flash key. It will always flash the line for the pre-programmed time when it hears the pre-programmed trigger code. No guessing about how long to hold down the hook-switch! Dial the code from a phone on either end of the call